This is the journey from being interested in a kit car, through to buying it and building it.
Saturday, 30 December 2017
First drive
Following the start up, I couldnt resist a small drive. The first attempt was a failure due to the clutch cable needing a bit of adjustment. 30 seconds later I had another go and this is what happened...
IT LIVES!!!!
So the day after boxing day i did a bit of fault finding and turns out id forgotten to connect a cable so couldnt connect to the ECU. After sorting that I loaded a map and the fuel pumps kicked into action! I primed the system by turning the ignition on about 6 times until the pitch of the pumps changed and could hear fuel in the engine and swirl pot. Then I turned the key to the final notch and.....
Somehow it started almost immediately with no problems at all. I couldnt' believe it!
Tuesday, 26 December 2017
ECU fitted
Yesterday, for Christmas, I was lucky enough to get the ECU for the car. I spent a few hours titivating bits today and finally tried to turn it over. I’ve not managed to get a map onto the ECU yet and there was no fuel onboard but it’s so close to starting up!
Subscribe to:
Posts (Atom)